RFLink v1.1 R51 (12-01-2024)
- New Device: Unitec W186-F Temperature sensor
- New Device: Amazon Basics Meat Thermometer
- New Device: Valoin Wireless Digital Meat Thermometer With Dual Probe
- New Device: Atech-WS308 temperature sensor
- New Device: Auriol 4-LD5661, Auriol 4-LD5972, Auriol 4-LD6313 ...

Xenomes wrote: Tuesday 26 December 2023 19:38 The only problem is that there are a lot of signals in the air. I will try to isolate them!

It depends a bit on the type of device but sometimes unfiltered logs are working better than cleaned/isolated data..

Yes, thats the idea

New RFLink firmware (R50) now available!

Check here: http://www.rflink.nl/

Changelog:

RFLink v1.1 R50
- New Device: Abalon Curtain remote (BE301) (receive)
- New Device: Lanboo Curtain remote (receive)
- New Device: Zaffer Blinds remote (receive)
- New Device: Marimex Pool Thermometer
- New ...

You can not control Keeloq devices.
They are "receive only".

You mention ESP, is the ESP used as a wifi module for RFlink?
When used in the normal way, RFLink(Arduino Mega) to Domoticz there is no such issue.
This means that Both RFLink and Domoticz are fine. You need to check your ESP wifi code.

It is still in development.
We do not respond to the ovious questions for which answers can be found on the website or the usual can you give a test version now or give sources

follow this:
http://www.rflink.nl/blog2/development

The Arduino is responding properly. Meaning that the firmware is loaded correctly.
If you do not receive any data in debug mode then you for sure have issues with the RF signal from the module not ending up where the firmware expects it.
This means either your pinout is not correct or you blew up ...

You did not add the device correctly.
You need to remove the RSY or whatever thing you created.
Then go to the hardware tab and use the create manual device button behind the rflink hardware.
In the popup you will need to enter a command as how it was received in a log file.. thus:
10;RTS;0F0F0F;0 ...

mma13 wrote: Tuesday 02 October 2018 15:43 - FREQ, well not the more useful (Hz)

FREQ = Hz..
0x32 = 50 decimal.. 50 hz..

This is not an official RFLink release!

RTS signals are received with a 433.92 version as well.
however, since RTS is sending on 433.42 the range is limited because of the frequency difference.
There are some tricks, like doing some modifications to a 433.92 module to slightly alter the frequency..

RFLink does receive and report the signals from an RTS remote control

Did you try the RFFind option to learn the signals?

The schematics depend on the used RF modules..

Did you get the device added/learned automatically or did you use the button on the hardware page?

Learning commands to Domoticz works with the 20;... commands.. it can not use the 10;... commands

Can you send me the commands that you logged?

If it does not work, try using the RFFind learning option.