After last domoticz update imperihome is not showing my rflink milight devices/switches anymore.... Tryed to reload switches but there gone. Anyone else have this problem? Or better a solution? :D Domoticz app is showing them and they are working through the browser so the problem is within ...

Yes did that, domoticz can see the new switch, but the rflink is sending a total different command as the wall switch, so this is not working.
I f I give the wall switch command through the rflink command line in domoticz, it is working.
Hope this will be supported in next rflink release.....

Nobody else using this switch? Rflink is sending the following command when switching: 10;MiLightv1;02b2;01;0000;ON Is this correct? Just adding another switch T2 CCT, and thsi one isn't working either.... Rflink picks up the signal in domoticz, add device, but no response. I can pair the bulbs in ...

I'm having problems with my milight t2 wall switch adding to domoticz.
Accept new hardware, push button on wall switch, rflink/domoticz adds new device.
But when I use the new device nothing happens.
Domoticz only see the device switching off when i use the wall switch.
What goes wrong over here?

I got an rflink and 1 milight ledstrip controller and one 6w rgbw bulb. Both are working with the milight remote as it should, ledstrip button 1 and bulb button 2.(rgbw,dimming all works) But in domoticz with rflink as I turn on the bulb the ledstrip is also turned on..... but in domoticz the switch ...

Only counting liters no flow control/valve.
Bought mine through aliexpress.
You can connect it anyway you want, for me piface is the easiest way for pulse counting,
and you can use the output on the piface for an extra electric valve.

For anyone getting tired of the misreadings from the optical sensors with their watermeter,
I can recommend this flow sensor. I use it in combination with my piface board, it's working excellent, no more spikes/drops etc...
Easy install too.

Only for the milight controller? Or is this working for milight through rflink also? Would be nice!
Confirmed: working with rflink too!

Great!
It is working now as it should, i was thinking of going back to the piface but now
I stick to mysensors.

Same problem over here....
Before I used a piface all was good, but now with mysensors not.
Same as you total value is x2.

Great app! Only problem for me is the opentherm-gateway thermostat..... The setpoint is verrrry bad readable, light grey text on white??? I can not set a temp, if I can not choose one. Plus the temps are all in half degree (e.g. 19.5/20.5/21.5), that's exacly what my Honeywell don't accept. Maybe ...

Label on the box says : Hongjingtian,
according to the Ispy website there's no jpeg snapshot........
http://www.ispyconnect.com/man.aspx?n=HongJingTian
Just rtsp://ip-address:554/11
Chipset can support it but firmware not I think.

EDIT: cam is HI3516C
See image, onvif compatible, 1080P, 3 streams.
Viewable through the danale app on android.....
In a browser I can view the cam, and also vlc is displaying perfectly. Even in synology surveillance station he is working good.
But not in Domoticz.
Hope anyone can help.

Can someone tell me how I can integrate my ip cam? It is using the rtsp protocol like: http://ip-address/11 That's 11 for mainstream, 12 for middle stream and 13 for small stream. If I enter the data in domoticz it is not working, I think domoticz is going wrong at the videourl, which must be 11 for ...