pushover sound

[tiga]

im testing out pushover and have the following problem:

in blockly when specifying the sound(in whatever prioroty), i get the "standard" sound on my Phone.

via the pushover-website sending a test message it works perfect!

how to solve this?

thank you!!

[Denny64]

Is "Always use default tone" unchecked on the Pushover app?

For me it works properly. Domoticz 3.5877 on Rpi3.

[tiga]

Yes it is unchecked

[Denny64]

Which domoticz version do you have?

Has the same behavior in switch notification?

[tiga]

Version: 3.8153

in switch notification i cannot chose a sound

[tiga]

just did a test with sending a message in lua...same result

[Denny64]

Try to set two different sounds in the app, not stock sounds, (one for normal level and one for alarm) and try to see If Domoticz works well. Don't forget to check "Always use the default tone".

If It works, then go back, uncheck "Always use the default tone" and test If different stock sounds are correctly played with Domoticz.

[George]

Hi, Same problem here.

No matter what i tried, I alway get the default tone (Even tried with a dummy switch):

Event test schakelaar (Dummy Switch).JPG (33.1 KiB) Viewed 1365 times

Played a lot with settings in App, but cant solve the problem.

settings 1.JPG (94.59 KiB) Viewed 1365 times

What am i doing wrong?

Raspberry Pi 3 Model B+ | Domoticz V4.9700 (Build Date: 2018-06-23 16:24:51) | Aeotec ZW090 Z-Stick Gen5 EU

[George]

Strange, but in case i choose:
Through subsystem "all", than the sound choice works.
But Through subsystem "pushover" I alway get the default sound and sound choice plays alway default sound, no matter what i choose.

Through subsystem all sound choice works but default sound when subsystem is pushover.JPG (34.54 KiB) Viewed 1360 times

Ofcourse I do not want to send it to all subsystems! Only to pushover.

[tlkg]

Any new developments on this?
I have the same problem, when Pushover is selected, notification sound is always the "Default" regardless of what is specified.

[Plantje]

I have a similar issue with the notification sound of Telegram.

For some reason every movement detected on my multi sensor is seen as a complete new category by my phone.

See this: https://www.domoticz.com/forum/viewtopi ... 94#p203267