Hi. I have a heat pump from which I receive many measurement values ​​via MQTT to Domoticz, including device (336) "5C54 Compr. consump. tot" and device (339) "5C57 Aux consumption tot". Now, I want to add these two MQTT devices (336) 5C54 + (339) 5C57 and display the total sum in device TotalActual ...

Hi. I wonder if someone can help me write a script that uses "Counter Incremental" Energy? I have a Bosch Compress 7000i AWE 13 kW air/water heat pump. I see, among other things, the heat pump's total energy consumption since the heat pump was installed via Domoticz unit "HP_Supp energy tot" for ...

Intresting Mats! Do you have an indoor temperature sensor or does lowering Room temp setpoint "do the trick" without it? PS My MQTT-data is stored in InfluxDB and is displayed using Grafana e,g, https://rogerthn.se/grafana/d/HaQJPWg4z/h60-imageit?orgId=1&refresh=1m Good night. Hi rogerthn. I have ...

Hi, it´s me again.....

I just want to say that at MQTT from HusData to Domoticz works now..... Hurray!!!!

I have to remove text "Domoticz" in MQTT_PREFIX in HusData config´n, then all sensors come in to Domoticz.


Have a nice weekend!


Best,
Mats McLund

Hi Ric. Thank you for your answer! :P I have done a script via Blockly as you can see in picture. This script also works very well. Natt och dagsänkning i Domoticz - Opera.png But this solution is temporary until I have MQTT to work in Domoticz. All data sends from Husdata as you can see in picture ...

Hi. We have a Husdata H60 heat pump interface connected to a Compress Bosch 7000i AWE air/water heat pump. It is one CR10 thermostat that controls the heat pump. I get all the desired values to Domoticz via LUA Script wich Ric68 has written. Big thank´s to Ric68 for this exellent code!!! :D local ...

Hi again. Now is CC2531 sniffer up´n running again. I have just forget to run "sudo systemctl enable zigbee2mqtt.service"...... :D But, I can´t get Domoticz to show right temperature data from my WSDCGQ11LM Aqara Temperature and Pressure sensor via zigbee2mqtt. Domoticz only show text and not any r ...

Hey rodaman. Tnx for your tips, but hey Houston, we just got some new problems here..... ;-) Now will the CC2531 sniffer shutdown (green lights turn off) after ca one minute after Raspberry reboot... This problem is new.... So I must find a solution on these sniffer problems first I suppose. I will ...

Hi there. I think I need a little help..... ;-) I can´t get Domoticz to show right temperature data from my WSDCGQ11LM Aqara Temperature and Pressure sensor via zigbee2mqtt. Domoticz just show only text and not any data as you can see in picture. 2020-12-28 14_35_11-Domoticz - Opera.png But, it ...