Thanks

I have the same situation. My Domoticz instance is working only for switches and buttons directly connected to Domoticz via USB mysensor gate. It is working. Most integrations switched to HA . I avoid any upgrade of Domoticz because most of them produce crashes. The biggest issue of Domoticz is MQTT ...

After using Domoticz for almost 8 years my only advice is switch to Home Assistant.

Ok, I am using integrated plugin for Onkyo.

Also try to plug off and plug in sniffer.

Try to pair few times more by pressing buton on sensor for 6 sec. My was added after several tries.

What port u used? My Onkyo is NR555 and working and a port is 60128.

Thank you for the script. I was thinking more that notification should be when non "0" occur during 24hrs. It could be sign that I have constant usage, very small but constant. What is "waterTotal" as a value. Maybe I can figure out how to write the script by me. I am very appreciated for your help.

Ok, sorry. Let say 24 hours because I can see in a daily Domoticz report every night I have zero usage at some point so I do not have a little leakage. No need immediate action, just check if 0 occured during last 24 hours. Maybe I am wrong but I thought Domoticz keep detailed values for 24 hrs.

During 24 hours I would like check if there is 0 liters usage. It should be especially in the night in my case . If 0 never occur for given time- alarm.

I was thinking like, it should be 0 (zero) liter at some point in 24 hours. If there is a constant liittle leakage it will never be 0. Am I wrong?

My friend got bill 200E for water. 2 times. After that he discovered that he had very little leakage from woodburner where is water valve for emergence. If there is power cut and woodburner is full of burning wood and pump stop pumping hot water, woodburner could explode so thermovalve open cold ...

It works!!! Thank you. I have to study DzVents better.

Script is working excellent also for me but i would like add switch in section when alerts is on. if litersPerMinuteNotify > maxLitersPerMinute then --I added here execute = function(domoticz, alert_woda) local alarmwoda = domoticz.devices('Woda Alarm') alarmwoda.switchOn() end But switch state Off ...

GeoBonas wrote: ↑Friday 20 September 2019 19:21 You must read https://www.domoticz.com/wiki/GPIO
Active low relays.

It will be a lot easier if that was an option in switch setup.

Thank you very much. It works finally...

It is not possible to set up higher temperature than 30'C..
!!!... Please correct that...

For set temp should be from 4*C to 28*C. This is example for Danfoss thermostat. Now is from 10 to 30*C. And for my MySensors HVAC device set point from 4*C to 55*C ;) Currently I get 10 to 30*C But when do you set your thermostat to below 10*C or above 30*C? Few example: Boiler, fireplace ...

I have especially bought Domoticz Pro app to have full controll of my Domoticz setup. I found out it is not possible to set temperature higher than 30'C in virtual thermostat. I have to controll my boiler and fireplace. It is very disapointed. Why it is so difficult to change it? Many users ask for ...

How to name it in english or establish switches (virtual sensors) when you press button, switch selector change position from 0 to 1. When you press button again switch selector change position back to 0.