Did you gave the devices a location in the room planner thingy?

"ok Google, sync my devices"


But on the Controlicz side I don't see the newer devices either. How can I resync between local Domoticz and Controlicz? Or should this be synced everytime? Because I have different devices that Controlicz doesn't spot.

I also sometimes use other icon types, but it ...

How can you update devices? I can't get controlicz to see my new switches. Not even after I unlink with Google Home.

I have a full DIY RFLink build, without a neat PCB.

I soldered the SMA connector to my superheterodyne RXB12 receiver

http://www.atbrask.dk/wp-content/uploads/2016/01/rxb12.jpg

I soldered the middle pin of this thing:
https://media.rs-online.com/t_large/F7839638-01.jpg

To the antenna hole ...

A question on 868 hardware; FSK or OOK

Trying to set up communication between an Orcon home ventilationsystem (MVS15). Frequentie 868,3 MHz and on the PCB of the Orcon there is a CC1101 chip visible.

Just wondering, which Aurel 868 MHz module is the preferred for the above system; The Aurel 868 ...

Okay, I will test later with the other pin connected instead of the current one. But now it works perfectly.

Thanks for making this firmware.

I already tried with one pin in 16 and one in 19. And change this around. This didn't work. However I decided to unplug randomly one of the two data pins and have only one cable to pin 19. Now it's working perfectly :-). Will adding the other one to 19 also (will need to split the cable then) give ...

Hi,

I'm trying to setup my RFLink functionality.

I'm using a cheap FS1000A as a transmitter and I bought a superheterodyne module named RXB12 as a receiver.

http://www.eeant.com/image/rx-receiver-module-et-rxb-12-433mhz-434mhz-eeant-technology.gif

Because it wasn't listed I choose the pinout ...

Does anyone know whether I will need a Pull-up resistor with the Kaifa E0025?