3 Phase meter

[willem9136]

I'm preparing a Domoticz setup for someone else.
It turns out they have a 3 phase meter Landis & Gyr E350.
I have a 1 phase meter so I can't test the 3 phase environment at my place.
Domoticsz runs on a PI-3B+ and using the P1 over USB and an inverter and an FTDI into the USB0 port.
This setup runs fine at my place.

However I wonder what will happen when I bring the meter into the 3 phase environment.
Will automatically the L1, L2 and L3 meters show up in the Devices window of Domoticz?

Who can tell me if I have to do extra things in the configuration for using this 3 phase meter setup?

And an additional question, Is the Landis&Gyr E350 also having an inverted P1 output?

[erem]

However I wonder what will happen when I bring the meter into the 3 phase environment.
Will automatically the L1, L2 and L3 meters show up in the Devices window of Domoticz?

Yes, the missing devices will be created automagically.
if not, just delete and recreate the hardware

Who can tell me if I have to do extra things in the configuration for using this 3 phase meter setup?

nothing to do

And an additional question, Is the Landis&Gyr E350 also having an inverted P1 output?

yes, inverted. you may need a 1k pullup between pin 2 and 5 at the meter, try without first.

17-03-2021 11-16-48.jpg (19.58 KiB) Viewed 421 times

[willem9136]

Thanks Rob.