Hi all,
I've paired an Aqara vibration sensor to my Zigate but how can I adjust the sensitivity?
Aqara vibration sensor
Moderator: leecollings
-
Damsee
- Posts: 58
- Joined: Thursday 20 April 2017 1:17
- Target OS: Raspberry Pi / ODroid
- Domoticz version: 4.10717
- Location: France
- Contact:
Re: Aqara vibration sensor
Hi,
You need to set the paramter through the Zigate web admin page which should be available at http://yourIP:9440/
Go to "Settings" and you should get the following:
Documentation is available : https://github.com/pipiche38/Domoticz-Z ... nf.json.md
You can set the sensitivity to low, medium, high
You need to set the paramter through the Zigate web admin page which should be available at http://yourIP:9440/
Go to "Settings" and you should get the following:
- aqara.png (14.16 KiB) Viewed 867 times
You can set the sensitivity to low, medium, high
RPI3 Raspbian Buster + Domoticz v2020.1 stable + RFXtrx433E + Z-Stick Gen5 + Amazon Echo (alexicz)
x5 THGN810 / x5 ZMNHJD1 / x2 Flood sensor FGFS101 / x1 Smoke sensor FGSD002
x1 ZMNHAD1 / x2 FGS213 / x3 Wallplug FGWPE/F / NodOn Soft remote CRC-3-6-0
x5 THGN810 / x5 ZMNHJD1 / x2 Flood sensor FGFS101 / x1 Smoke sensor FGSD002
x1 ZMNHAD1 / x2 FGS213 / x3 Wallplug FGWPE/F / NodOn Soft remote CRC-3-6-0
-
GilbertvH
- Posts: 18
- Joined: Tuesday 23 June 2020 11:01
- Target OS: NAS (Synology & others)
- Domoticz version:
- Contact:
Re: Aqara vibration sensor
Damn... Missed that one! Thanks!
-
dheuts
- Posts: 65
- Joined: Monday 25 March 2019 15:14
- Target OS: Raspberry Pi / ODroid
- Domoticz version:
- Location: Brunssum, Netherlands
- Contact:
Re: Aqara vibration sensor
I have two of these, connected with Zigbee2mqtt.
One of the sensors is going back to Off after one second, the other one stays on Vibration or Tilt, so I have to put it back to off state with a Blockly command after a couple of seconds after movement.
What is normal behaviour? How does it work at your places?
Any idea how to get them both working the same way?
One of the sensors is going back to Off after one second, the other one stays on Vibration or Tilt, so I have to put it back to off state with a Blockly command after a couple of seconds after movement.
What is normal behaviour? How does it work at your places?
Any idea how to get them both working the same way?
Raspberry Pi 4 With Domoticz - RFXCom - Tuya Wifi LED lights - Chuango Alarm - Zwave+ - Zigbee2MQTT - Anna Thermostat - Broadlink IR, P1 - Eufy Robo Vacuum - Worx Robo Mower
Who is online
Users browsing this forum: No registered users and 1 guest