blockly for roller shutter
Moderator: leecollings
-
- Posts: 5
- Joined: Wednesday 24 June 2020 14:01
- Target OS: Raspberry Pi / ODroid
- Domoticz version:
- Contact:
blockly for roller shutter
Hallo friend, sorry for my english... I have domoticz and sonoff dual and 4chpro to control roller shutter. I try to create an event to close partially by given 2 command to releè within few second but not work... what i wrong?
-
- Posts: 18
- Joined: Wednesday 06 January 2016 11:34
- Target OS: Raspberry Pi / ODroid
- Domoticz version: 2022.2
- Location: Dalfsen netherlands
- Contact:
Re: blockly for roller shutter
did you try on for 4 seconds?
How is the shutter connected in Domoticz?
How is the shutter connected in Domoticz?
-
- Posts: 5
- Joined: Wednesday 24 June 2020 14:01
- Target OS: Raspberry Pi / ODroid
- Domoticz version:
- Contact:
Re: blockly for roller shutter
ciao har0543 thank you for the answer! the 2 shutters are connect to domoticz by a sonoff 4ch pro R2 with the latest espurna fw. I tried for 4 seconds, and less but no work... so the sonoff seem no receive the 2' impuls to stop before the seconds pulse time set on sonoff switch.
-
- Posts: 109
- Joined: Tuesday 02 October 2018 20:52
- Target OS: Raspberry Pi / ODroid
- Domoticz version:
- Contact:
Re: blockly for roller shutter
Are you sure on is the right commando? Isn't it stop? When you want to stop it? How does it work when you do it manually?
-
- Posts: 5
- Joined: Wednesday 24 June 2020 14:01
- Target OS: Raspberry Pi / ODroid
- Domoticz version:
- Contact:
Re: blockly for roller shutter
Yes, "on" is the right command , exemple: when I use rf remote controller by rfbridge: I push 1 time to open the roller, and another time on after 3 seconds for stop it.
-
- Posts: 109
- Joined: Tuesday 02 October 2018 20:52
- Target OS: Raspberry Pi / ODroid
- Domoticz version:
- Contact:
Re: blockly for roller shutter
Hmm ok. And if you use a dummy momentary switch to activate the the roller.
Then you can try this by activate this once and again after 4 seconds. To make sure all commandos are right.
Then you can try this by activate this once and again after 4 seconds. To make sure all commandos are right.
-
- Posts: 5
- Joined: Wednesday 24 June 2020 14:01
- Target OS: Raspberry Pi / ODroid
- Domoticz version:
- Contact:
Re: blockly for roller shutter
...friend but... a dummy momentary switch it's that i create to control sonoff 4chpro with domoticz... or not?...
Who is online
Users browsing this forum: No registered users and 1 guest