blockly for roller shutter

[therealman]

Hallo friend, sorry for my english... I have domoticz and sonoff dual and 4chpro to control roller shutter. I try to create an event to close partially by given 2 command to releè within few second but not work... what i wrong?

here my event

roller.gif (21.71 KiB) Viewed 836 times

here my event

roller.gif (21.71 KiB) Viewed 836 times

[har0543]

did you try on for 4 seconds?
How is the shutter connected in Domoticz?

[therealman]

ciao har0543 thank you for the answer! the 2 shutters are connect to domoticz by a sonoff 4ch pro R2 with the latest espurna fw. I tried for 4 seconds, and less but no work... so the sonoff seem no receive the 2' impuls to stop before the seconds pulse time set on sonoff switch.

[wouterlet]

Are you sure on is the right commando? Isn't it stop? When you want to stop it? How does it work when you do it manually?

[therealman]

Yes, "on" is the right command , exemple: when I use rf remote controller by rfbridge: I push 1 time to open the roller, and another time on after 3 seconds for stop it.

[wouterlet]

Hmm ok. And if you use a dummy momentary switch to activate the the roller.

Then you can try this by activate this once and again after 4 seconds. To make sure all commandos are right.

[therealman]

...friend but... a dummy momentary switch it's that i create to control sonoff 4chpro with domoticz... or not?...