FAKRO : stop command while closing doesn't work

[keros]

Hello every body,

I have installed two roof windows from Fakro (FTU-V Z-Wave) with a blind (ARZ Z-WAVE). The windows and the blinds are motorized and it uses Zwave to communicate : that great (compaired to Velux)

The little disadvantages is that if I open the windows while the blind are closed -> I brake it ! (it only admit an openning of 20 cm).

Image3.jpg (108.64 KiB) Viewed 838 times

I wanted to use Domoticz to avoid this problem. My idea was to use the dzvents .stop() function.

I tried the folowing scenarios :

• Windows closed : command Stop sent > Nothing happen (that normal)
• Windows opening : command Stop sent > the windows stops where it is (that what I want)
• Windows opened : command Stop sent > the windows starts to close
• Windows closing : command Stop sent > the windows continues to close

My Zwave Stick is a AEON Labs ZW090 Z-Stick Gen5 EU.

The command while opening or closing should have the same effect

I have the same problem on the two windows and the two blinds.

Does anyone have some Fakro devices ?

Thanks for you're help.

[keros]

The device is not reconized in the Zwaves device list.

Image4.jpg (43.46 KiB) Viewed 822 times

Is there a link with my problem ?

[rapscallion42]

Hi You have to do the opposite command.

a) when the window is closed and you send an open command, you can stop it somewhere by sending a close command.
b) when the window is open and you send a close command, they will begin to close. if you want it to stop somewhere before they are fully closed, then send an open command.

[keros]

Thanks for your reply.

The idea was to make a script which would protect the blind form an inapropriate movement of the windows even. For example, if I use the remote or the button, I don't know the windows moves : i can't send the opposite command.