Can't add a Dummy Selector

[mAiden88]

Whatever I try, do not get a dummy selector added to Domoticz. Have tried the following things:

- add dummy, add it via manual light

- via create virtual sensors

What do i wrong?

[HansieNL]

Hardware - Setup - Dummy (Create Virtual Sensors) - Sensor Type = Selector Switch

[mAiden88]

Hardware - Setup - Dummy (Create Virtual Sensors) - Sensor Type = Selector Switch

I did @HansieNL.

Screenshot_73.png (14.32 KiB) Viewed 2826 times

But dont see the Dummy Selector.

[Venzent]

Under Hardware, first add the Dummy (under the list of already available hardware), then when added, you can add dummy devices

Schermafbeelding 2018-06-06 om 17.33.18.png (348.69 KiB) Viewed 2821 times

[mAiden88]

@Venzent,

I did:

Screenshot_74.png (9.21 KiB) Viewed 2819 times

[Venzent]

Mmmm, ok, and when you select "Create Virtual Sensor" , give it a name and type and save it, it does not appear under " Switches".
Is there anything in the log?

[mAiden88]

Mmmm, ok, and when you select "Create Virtual Sensor" , give it a name and type and save it, it does not appear under " Switches".
Is there anything in the log?

Unfortunately, also via Create Virtual Sensor, do not get any of my dummy switch.

[Ric68]

It seems that there is a general issue with adding switches.

I just got IKEA-Tradfri plugin to work and I can see 10 switches in the devices-list (and all is added with the "Add Light/Switch Device" commando, and I can also control them from the devices-list, but the Switches-tab is completely empty

I also tried to add a dummy switch without success as mentioned in this thread

Tested on both 9573 and 9580 on a Raspberry PI 3+

[mAiden88]

Have it solved. Apparently it was my browser, Chrome does not see the selector added, but Internet Explorer does. (I did not try Edge, I do not like it.)