Creating devices for included node Topic is solved

[cincuranet]

Hi, I included new node on my Aeotec Z-Stick using the button (not via Domoticz), because it was too far from it and I had to get physically closer. Now I see the node in the list in Hardware, but I don't have any new devices in Devices. Is there a way to create these? I can control the node from OZW Control Panel just fine. So I think I "just" need to somehow create these devices.

[Skippiemanz]

Hi, I included new node on my Aeotec Z-Stick using the button (not via Domoticz), because it was too far from it and I had to get physically closer. Now I see the node in the list in Hardware, but I don't have any new devices in Devices. Is there a way to create these? I can control the node from OZW Control Panel just fine. So I think I "just" need to somehow create these devices.

Try sending the heal command trough domoticz. Or wake up the device. The devices should appear in the Un used tab

[cincuranet]

The device is always on ("Z-Wave+ node Always On Slave"). I tried clicking on "Heal" button now. But even after few minutes not a single device appeared.

[cincuranet]

Just to be sure, I also restarted my Raspberry Pi and for a while I saw "Not all Nodes have been Queried yet, OpenZWave not fully initialized yet!". But no new devices after that.

[cincuranet]

Ahh, finally solved it. I enabled "Accept new Hardware Devices" and then rebooted my Raspberry Pi. New devices appeared then.

Not sure whether having "Accept new Hardware Devices" off makes a "security" (or any other) difference, but I keep it that way.