Thanks a lot! I will look into this and give it a try.

I use one Danfoss and three Eurotronics devices. Two using Zwave and two using ZigBee.

Cheers from Cologne,
Sascha

That did the trick! Thanks!

I got one additional question: Is there an option to set the Thermostat only to 8 degrees if the door is opne longer than 30 seconds or a minute?

Cheers,
Sascha

I will try that and give you an update!

Thanks for the hint!

Cheers,
Sascha

Yes!

When I open window or door, it is set to 8 degrees. But when this window or door is closed again, it's not set to 17 or 20 degrees depending on the current temperatur.

Cheers,
Sascha

Thanks!

I changed the first part and that's working now. But as soon as I close either window or door, the thermostat is not set back to 17 or 20 degrees. Do I have to change the conditions in the second and third part as well?

Cheers,
Sascha

Hello everyone, I have a Blockly configured for every room where I have a Zwave thermostat. In these rooms I usually only have one window with sensor to check if the window is opened or closed. I have also installed thermometers to check the temperature. If the window is opened, the thermostat ...

It's working! Fantastic!

Thanks a lot!

S.

I hope this is the right output... 2018-03-22 21:27:23.318 (Philips Hue) Lighting Limitless/Applamp (Scene Sonnenuntergang Savanne) 2018-03-22 21:27:23.320 (Philips Hue) Lighting Limitless/Applamp (Scene Hell) 2018-03-22 21:27:23.322 (Philips Hue) Lighting Limitless/Applamp (Scene Aus) 2018-03-22 21 ...

Hi ycahome,

Could you please tell me what a code placeholder is?

Thanks,
Sascha

Hi, is someone else getting 'key errors'? 2018-03-22 00:24:42.788 Error: (PP-Manager) Something went wrong with update of MoonPhases 2018-03-22 00:24:42.808 Error: (PP-Manager) Something went wrong with update of BatteryLevel 2018-03-22 00:24:52.696 Error: (Moon Phases) 'onHeartbeat' failed ...

That's working!
On and off delays are working differently within scenes. I though they where working like they do in switches, where they automatically switch off after a defined time.

Thanks for pointing me in the right direction.

Sascha

Hello,
I would like to turn on serveral 433MHz RC wall sockets and after a delay of a few seconds I would like to send a Logitech Harmony command.

How can I add this delay to a scene?

Thanks in advance,
Sascha

Thanks for the fast reply!
That was the problem.

Thanks,
Sascha

Nope, the RasPi is powered over a dedicated power supply. A technician told me that those routers are very fragile to other frequences, if they are placed ro near to a TV, speakers, etc. But this could also be a lame excuse for almost every error...

Sascha

Hi, I was playing with Locative and pasted the URL into my browser and everything was working. But now I am receiving this error message every time. { "message" : "Error sending switch command, check device/hardware !", "status" : "ERROR", "title" : "SwitchLight" } Here is my command: https ...

Hi all, my Domoticz installation was running well with the RFX433 until I added the above mentioned USB stick. Now I have to reboot my Cable router (AVM Fritzbox) three to four times a day. As soon as I shut down my Pi, removed the Z-Wave Stick and just used the RFX433, everything was working as it ...