I found it!

To set a Setpoint you use the "Set Setpoint" function that you can find in the tree on the left under "Devices" ==> "Setpoints".

I probably doing something wrong but I can't update de Comfortsetpoint of these thermostats from an event in Domoticz.

Everything works fine when I set the Comfortsetpoint of the Thermostat using the dashboard in Domoticz.
But when I set it to a certain value from an event in Domoticz nothing ...

I combined the post of berkens and tvurce and created a new eur_spirit.xml file which will show you some help text in Domoticz with the settings of the Eurotronic Spirit.

One question I have : Can someone tell me how I can update existing Eurotronic Spirit thermostat controllers in Domoticz?
With ...

Thanks for your reply philchillbill.

I did remove the Aeotec Z-stick in Domoticz (using the GUI), close Domoticz, restart my Raspberry Pi, start Domoticz, add the Aeotec Z-stick ==> no changes, The Aeotec still doesn’t react on any changes in the config.

It does look like Domoticz keeps the ...

Hi,

I can't update the Aeotec Z-stick controller configuration (and switch of the LED). When I set the "Controller blinking" to disabled and I click "Apply configuration for this device", nothing changes on the Aeotec Z-stick. The LED keeps blinking.
Including and removing nodes works fine. Also ...

It is working now!

This is what I did:
-Removed all the devices of the FGMS-001 from the device list in Domoticz
-Removed the node FGMS-001 from the Aeotec Z-stick in the Hardware
-Reboot the Raspberry PI
-After reboot, check the hardware. The FGMS-001 was in the hardware list, without me inclusing ...

Hi,

I have a problem with the temperature sensor of the Fibaro FGMS-001, it is stuck on 25.2 degrees Celsius.
The other sensors like motion, light and tamper work fine and give updated values in Domoticz.
I hope there is someone who can help me with this issue and can tell me how I can get the ...