Solution could be to make your USB device use the same port ALL the time. See: https://www.domoticz.com/wiki/PersistentUSBDevices Because sometimes after reboot, or when you manually change the USB port of a device the OS comes up with an other USB port for the device. That might depend on the ...

Hey everybody! I'm running domoticz 2020.2 on a Raspi 3b+ without any problems since month. Now I did do a backup using the raspi card tool. When I deconnected the sd card the system went nuts. The zwave.me stick wasn't shown in hardware anymore - everything gone. Now I plugged it into a different ...

Question: How can I set the colour?
I'm a newby and can only do Blockly... but if you give me some Lua or DZVents lines I think I can modify them for my needs. Just I need a hint...

Thanks!

Boris

Hey!

I'm using RFLink and a cheap (yes I know...) Water Sensor to detect flooding. Unluckily the sensor only sends out "OFF" Signals and I don't figure out how to handle this to switch off a wallplug.

Can anybody help?

Thanks!

Boris

Hello! I attached a Arduino Mega and RFLink Board (from Nodo Shop) to my Raspi and Domoticz yesterday. I Already added successfully a PIR - running well. Today I bought a Smartwares SH5-RPS-36A Plug - but what now? How can I connect this to Domoticz? I have read a lot of stuff... but doesn't have ...

Hello! I attached a Arduino Mega and RFLink Board (from Nodo Shop) to my Raspi and Domoticz yesterday. I Already added successfully a PIR - running well. Today I bought a Smartwares SH5-RPS-36A Plug - but what now? How can I connect this to Domoticz? I have read a lot of stuff... but doesn't have ...

Hello!

First: I'm a newby to Domozicz...
Questoin here: why do BOTH if's start up?

It shutrun between 03:00 and 21:00 - and it does.
But the following if's go both active, even if the temperauter is above 21°. And I don't get it why...

Please help!

Thanks,

Boris