I've bought them past December for our bedroom and the blue LED is to bright. So for the curtain controller and the 2 channel switch the parameter to enable/disable the blue LED is well documented in the manual. But for the 1 channel switch it is not. I found the parameter myself. So to complete ...

almost 2 years later ... I'm still cleaning up phantom Zwave connections every 2 weeks or so ... still no solution for this VERY annoying problem ? And you are not alone, I have this behavior with Fibaro RGBW dimmers too with Domoticz for years now. But not with my other domotica server that runs ...

I started to add dashticz to my domoticz installation because I like this very much. First of all thanks to the creator of this nice addition to Domoticz. You can do settings through the dashticz dashboard but when click save and close the settings screen, come back later in the settings none of the ...

Maybe you already did this but just for the record because I saw your screenshot with settings on the other topic; Did you have the settings for the USR TCP232-T2 correct? The wrong baud rate can cause problems with the communication Set it as a server only on port 23 Disable Similar RFC2217, can ...

I did some communication with Remco from Nodo Shop past months about adding an USR TCP232-T2 possibility directly to the board. We did exchange ideas about this and how I did it. I received a message today from Remco of Nodo Shop that they now have a version of the OTGW where you can also directly ...

Sorry read your message just today.
Hope you already find the solution but if not here are my settings of the USR TCP232-T2 to help you and others.

I also just build the Nodo OTG version this week with an USR TCP232-T2 ethernet module. The on-board voltage regulator was running to hot when I added the ethernet module directly to the 5V connection where you can place the NodoMCU. So I added an second voltage regulator to the OTG board. There are ...

That depends.. If you have a pcb from nodo show with version 1.1.3 or higher you can put the nrf in the socket. If you have no PCB and just want to connect the NRF to the Mega pins then the pinout is descirbed on the rflink wiring page: http://www.rflink.nl/blog2/wiring under NRF24L01 - MiLight ...

Searched a lot on internet, read the whole website from RFLink, lot's of topics here and search the nodo webshop (read all the PDF documents found in the download section) but cannot find any good wiring circuit about 2,4GHz board for use with MiLight. I read that the nodo connector on the PCB is ...

If I could help I will but I cannot program at all.
Is it so difficult to add the name we give in the node list to the device list?

I just started with Domoticz but have a lot of experience with other domotica software and are totally agree with this. I have nodes added in the hardware interface and name them but going to devices I can't find anything back here. Just a mess of undefined devices. This is a really big showstopper ...