I have the same observation.

Any progress on this?

Hi, I am struggeling to unbind the Ikea remote from its default group. Has to do with my lack of experience with mqtt. I am using MQTT Explorer to look at the mqtt communication. What must be the proper syntax to sent an unbind message? The remote is registered in the zigbee network, i can check the ...

Finally i decided to remove the sensor from the network. Reconnect, and now the sensor works as it is supposed to work.

Don't know why; it is the result that counts

The movement signal reacts identical to 'Burglar'. Also 5 minutes active

What I see in the Domoticz log is that "Burglar" becomes active ('on'), of course when movement is detected. And then after 5 minutes "burglar" again changes state, to 'off'.

The only other thing I can think of: I have used a Blockly script to switch on a light on a movement alarm, with a timer to leave the light on for 5 minutes. The script is not active currently, however.
But I would not expect to see any relation between a script and the behavior of the motion sensor

12 seconds.

Sensor has all settings as per default settings.

I still do not understand this.
My sensor cancellation delay setting is 30 seconds, but the alarm stays active for 5 minutes.

Thanks for the feedback and explanation.

This is exactly my confusion: the cancellation setting is 30 (corresponds to seconds, says the manual), but the actual time an alarm is active is 5 minutes.

So: how to reduce this 5 minute period?

Hi, I have a Fibaro FGMS-001 motion sensor in my network. Works fine. What I try to understand is the time that elapses between the moment of triggering the motion alarm and the moment the alarm is cancelled. in the present situation this time frame is about 5 minutes. Whereas I would expect it to ...

Nobody?

Hi, After a long time of error free operation on latest stable Domoticz the log suddenly shows a lot of PONG messages. Nothing has changed in setup or switches. And, what is worse, a RfLink switch (kaku) starts responding unreliably. I found that the pong message is not something to be concerned ...

I did not really expect it to work. Just wanted to let you know that i tried; with no success obviously

It would be nice to have a Domoticz plugin.
I tried to do a portscan on the Trådfri hub. Again no success, no ports found.

Lights are not recognised by my Hue bridge.

Now also for sale in Holland.

OK, thanks.

What needs to be on the SD-card? only the '/boot/cmdline.txt' file?

I have been using Domoticz with Razberry V2 anf an UPSPico for a number of weeks with high reliability. But now i tried to update the Pico firmware. With no success, sofar. Unfortunately now Zwave is not longer active. The Razberry is recognized in the hardware by Domoticz, but if i click 'setup' no ...

You are right, sorry for mixing up things. Made an error with copy/paste text. I currently have the Pi running from usb-stick. But did not use berryboot to get that working. I followed one of the many tutorials to copy Raspbian to usb-stick and subsequently run from usb-stick, by changing startup ...

Please have a look at berryboot. What is the advantage (if any) of using berryboot in stead of following the steps mentioned earlier in this thread: 1. sudo raspi-config 1.1 expand Filesystem 1.2 Change User Password 1.3 Change Timezone: set to appropriate timezone 1.4 Advanced Options: Option A3 ...

I never tried it, but i think it is possible to have 2 controllers in a zwave network. And then you can sent the configuration from one controller to the other. That must be a way to transfer your configuration from piB ro pi3.