Blockly/Domoticz acting weird
Posted: Thursday 17 September 2020 22:59
HI,
i have been trying to get an energy saving event running through Blockly.
Which most of the time works. but now almost once a day it shutsdown the AV plug without a good reason.
i have it setup the following way:
but the Shelly Plug now gets randomly shutdown by Step 2 that doesn't even contain the Shelly Plug inside the event.
of by an not existing timer.
i hope to find a way to eliminate these strange errors.
will plage screenshots of the log in second post because of limit of 3 attachments.
i have been trying to get an energy saving event running through Blockly.
Which most of the time works. but now almost once a day it shutsdown the AV plug without a good reason.
i have it setup the following way:
- Step 1 is seeing that the usage is lower than 10Watt.
- step 1 usage lower .jpg (75.94 KiB) Viewed 391 times
- Step 2 seeing usage is again above 10 watt after 2100seconds (20 minutes) and cancel shutdown.
- step 2 usage high again.jpg (86.69 KiB) Viewed 391 times
- Step 3 is seeing usage still is lower than 10Watt after 20 minutes. and shutdown Shelly Plug S.
- step 3 usage stays low.jpg (88.65 KiB) Viewed 391 times
of by an not existing timer.
i hope to find a way to eliminate these strange errors.
will plage screenshots of the log in second post because of limit of 3 attachments.