Domoticz

Allthough zwave setup says it is disabled, my LED still flashes. And is draining my battery.
simular symptoms: here
Anybody got it fixed?

Did you press the 'Save Changes' button at the bottom ?
If yes, could you try to select 'Control Panel' from the dropdown, and set the configuration here
What is your domoticz version ?

Control panel and domoticz both show parameter 10 disabled (led off). Pressed three times fast on the PIR button to wake device.
Older neocam version 1 work flwaless

Driving. Me. Nuts

I have had dealed with this a couple of months ago:
If I understand correctly Neo Coolcam released two different devices with same product type/Id.
For now openzwave didn’t support 2 config (version) file for same product, but it is something in pipeline.
The current work around is too and both entry in manufacturer_specific.xml file and comment one (in this case your, as the previous design). There seems to be some also for Fibaro and Qubino.

I just bought this PIR, and I'm seeing the same issue. Also changing the PIR Motion detection sensitivity to lower does not work.

Any ideas would be welcome.

Nevermind I got it working now. Just have to wakeup the pir by triple clicking the button inside right after sending an update from domoticz.

renerene wrote: ↑Sunday 16 June 2019 12:28 Allthough zwave setup says it is disabled, my LED still flashes. And is draining my battery.
simular symptoms: here
Anybody got it fixed?

Yes use the right XML configuration. Ozw has the wrong one...... I made an other one. See my other subject....

see: https://www.domoticz.com/forum/viewtopi ... 24&t=23085