Domoticz

I have this qubino smart meter and I have a problem. In Open Z-wave Control Panel I have all the values correct. Then if I look to the domoticz devices I don't have the the KWh value and I have the KVAh but expressed as W. please see the attached pictures.
best regards.

I have the same problem, I tried to remove the device, update domoticz to the last beta but no changes, still wrong values. Have you find a solution?

nvicente wrote:I have this qubino smart meter and I have a problem. In Open Z-wave Control Panel I have all the values correct. Then if I look to the domoticz devices I don't have the the KWh value and I have the KVAh but expressed as W. please see the attached pictures.
best regards.

As you can see from the attached screenshot, in the OZW control panel, the information are present and correct, like for yours: But the device appeare like "Unknown" and in the Log output screen there are errors reported by the Node005, the Smart Meter.

Is not possible that after 2 months no one can provide us any suggestion? Please, I hope that there is possible to find a solution.... I don't want to migrate to another platform and I'm really confident on the good quality of the Qubino products....

HELP US

I have the same node error that you show on your picture. I have the last Domoticz Beta update
regards

nvicente wrote: ↑Thursday 02 March 2017 12:31 I have the same node error that you show on your picture. I have the last Domoticz Beta update
regards

did you solve the issue or still no way to have the correct information in Domoticz?
I'm installing openhab, I hope to solve this way..... if it will be the same, I will replace the smart meter....

Regards,

Stefano