RFlink might support Mi-light and other protocols soon :)

[Stuntteam]

Yes, fully..

[Larsja]

What exactly is "2.4 Ghz, NRF24L01 with Milight wiring required"? What do i need to do with this? http://www.ebay.com/itm/310651702557

[deennoo]

You need to follow this wiring instruction : http://www.nemcon.nl/blog2/wiring

This device works (got one), I use a 5v to 3.3v converter to power it from my méga + 10uf condo.

Actually rflink doesn't use the fully power of this device, maybe next time

[burton666]

I don't understand, how do I pair/ control a mi-light bulb using only the domoticz gui? I have wired the nrf radio as the instructions .

[Stuntteam]

Without remote control:
Go to: http://www.nemcon.nl/blog2/faq
and scroll down to
"how to pair Milight bulbs without the original Milight remote control in Domoticz?"

If you have a remote control:
you can pair bulbs as usual.. make sure auto accept new devices is turned on for some time and press the ON button for the zone you want to use on the remote control..RFLink will detect the remote control signal and tell Domoticz about it.. it will then show up in your device list.

[burton666]

I only get "problems creating sensor" every time I try the commands.

[deennoo]

Please enable allow new device on your domoticz parameters
Which Domoticz version have you ?

[burton666]

I am using the latest beta of domoticz. I have checked the options to always allow all devices in the settings.
I have tried two different nrf radios and have checked the wireing several times.

[Stuntteam]

Check the hardware tab.. is firmware listed as version 42?

[burton666]

yes it is

[burton666]

And I have my mi-light just a 1m away from the RF-link gateway and I have unpaired the lamp in advance using the android app

[Stuntteam]

Range for sure is not an issue.
Check your PM..

[Larsja]

You need to follow this wiring instruction : http://www.nemcon.nl/blog2/wiring

This device works (got one), I use a 5v to 3.3v converter to power it from my méga + 10uf condo.

Actually rflink doesn't use the fully power of this device, maybe next time

Ah, thanks

I have the RFLink shield from Nodo-Shop.nl so im guessing then its just plug and play, gotta see if i find some drawings.

[deennoo]

Milight wiring is different from the nodo shield.

[Larsja]

Blast!

[Stuntteam]

Also, make sure you enable miglight after flasing the firmware..

[burton666]

Where? in domoticz?

[deennoo]

Where? in domoticz?

On RFLink loader who come with the R42 fw

[burton666]

I tried flashing again using the loader from r42. I see the buttons to turn ON/OFF nodo + milight but they are greyed out before/during/ and after the flashing, I can't press anything other than "upload firmware"

[deennoo]

Enable serail on rflink loader (i promise you will not create a black hole by try to press some button by your own)