Fibaro Door/Windowsensor FGK-101

[OCB73]

Hi there!

I bought some of these sensors and had a lot of problems to include them.
Tried the first one to include without luck. Resetted the sensor, also no luck.
So i tried the second one with the same result.

Googled a lot about that problem and only found 1 helping post.
Before you want to include you have to CLOSE THE SENSOR, that will help!

I don´t now why, but it´s working...

Regards
Oliver

[Egregius]

And how will you push the button if the cover is closed?
In my opinion it's only the tamper switch that needs to be closed for inclusion.

[robpow]

Isn't the external tamper switch under the sensor identical to the button inside the casing? Either way, both are labelled TMP in the manual:

http://www.fibaro.com/files/instrukcje/ ... 21-v23.pdf

However, I'm pretty sure I kept the sensor flat on a table with the case open so that the external TMP was pushed in and then triple-clicked the internal button when I added my three sensors. Maybe there are many ways to skin this cat.

Matt

[OCB73]

I didnt´t tried it with external button pushed and then using the internal,
but i will try it with my next sensor and give a feedback.

I only tried internal or external tamper alone with open sensor and no luck.
Since i closed the sensor, external one is working fine for inclusion with triple-click.

Oliver