Use this forum to discuss possible implementation of a new feature before opening a ticket.
A developer shall edit the topic title with "[xxx]" where xxx is the id of the accompanying tracker id.
Duplicate posts about the same id. +1 posts are not allowed.
For the beginning I wouldn't need some very complex Calculations but even easy stuff like "Increase User Variable", "Check for Temperature + x", "Multiply Numbers to convert units" would be very useful
I second that. Would be great for my "intelligent dimmer", which is controlled by the value of a user variable.
Example:
0 = off
1 = 25%
2 = 50%
3 = 75%
4 = full
A motion sensor would set the variable to 4, and start a timer.
Timer runs out: decrement variable and restart timer.
Variable reaches 0: dimmer to off, and cancel timer.
Last edited by manjh on Sunday 15 May 2016 17:50, edited 1 time in total.
In progress - will issue pull request once finished.
Extended Domoticz homebridge-plugin for latest Homebridge - adds temp/humidity/pressure sensors, power consumption sensors, DarkSkies virtual weather station support, YouLess Meter support, general % usage support & switch/lamp status checking!
Can't wait for this - going to use it to compare the current energy usage with that from 5 minutes ago, and notify me if something has stopped using energy (such as the dishwasher)
Domoticz on Raspi 3 and slave on ZeroW (running only with Broadlink plugin), Serial Mysensors GW on Arduino nano, Broadlink RM2, Rehau CO2 USB Stick, RF link 433 MHz, 2x Amazon Echo Dot (Controlicz), ESP2866 witk Espeasy, Sonoff
