RFLink keeps adding devices

[mistysnip]

Hi,

I've noticed that once in awhile I get new devices added to my list that I don't know where they come from. They are all switches with the subtype FA500. Any ideas where they come from?

Thanks

Screen Shot 2015-12-02 at 22.43.17.png (123.12 KiB) Viewed 3028 times

[klontje]

I have the same issue with X10 devices although I have disabled X10 as protocol in my RFXcom configuration. I live on a farm in the middle of nowhere with no neighbours in a range of 100meter...

Capture.PNG (37.53 KiB) Viewed 2972 times

[NietGiftig]

same issue with X10 devices
I live on a farm in the middle of nowhere with no neighbours in a range of 100meter...

Time to call the people from the x-files

We are not alone!!!!

[gizmocuz]

Easiest solution, when you have all your sensors you have/needed, goto settings, disable accept new hardware

[Backbone]

Same problem here too.
The option from Giz is a good one.
Edit: Just found out that in the device section on the top there is a small TRASHCAN icon to remove unwanted entries.

Paco

[mistysnip]

Good enough, Giz! I was just wondering if there was something wrong with my system. thanks!

[Stuntteam]

RFlink got a fix to avoid the additional FA500 devices. Will be released soon.

[Nautilus]

Old topic, but this fits the subject perfectly.

I have the "accept new hardware" box empty, but RFLink keeps anyhow adding sensors and devices. So far seems that it does it only once and when I remove it, it doesn't add it again even if I use the switch again. But all the time "accept new hardware" was off and neither had I pushed the "allow for 5 min" button. Is there something strange going on with my setup? I've just recently taken RFLink into use...

edit: false alarm, I had pushed the "learn" button once on the devices tab and only after looking at the logs noticed it initiates the same "allow new sensors for 5 minutes". Thought it accepts only until the "timeout"...