[347] Additional functionality to Mertik controller

[vvhillo]

Please add the UP and DOWN (higher flame, lower flame) functionality.

THNX!

[gizmocuz]

Could you check #2304, hope it works

[vvhillo]

Will check when I get home...thanks in advance (if it works )

[vvhillo]

Could you check #2304, hope it works

The good news is, it works but there is a BUT

My Fireplace was protected (with a password) then it does not work. You don't see the popup for the password or the control of the fireplace. If you disable the protection then it just works fine.

[jompie]

Hi, what do you mean with #2304? Can you explain?
Thanks

[vvhillo]

Hi, what do you mean with #2304? Can you explain?
Thanks

New beta version of Domoticz

[gizmocuz]

Could you check #2304, hope it works

The good news is, it works but there is a BUT

My Fireplace was protected (with a password) then it does not work. You don't see the popup for the password or the control of the fireplace. If you disable the protection then it just works fine.

Should now be fixed in #2205... please confirm

[vvhillo]

Could you check #2304, hope it works

The good news is, it works but there is a BUT

My Fireplace was protected (with a password) then it does not work. You don't see the popup for the password or the control of the fireplace. If you disable the protection then it just works fine.

Should now be fixed in #2205... please confirm

Yes works great! Superb job! Thanks!!

[jompie]

Hi,

Indeed now Up and Down are also working. Please add also these two commands (e.g. as JSON commands):
Run UP/2nd Off
Run Down/2nd On

(thermostat3_sRunUp 0x4
thermostat3_Off2nd 0x4
thermostat3_sRunDown 0x5
thermostat3_On2nd 0x5)

That would be very appreciated

[jompie]

Hi

Commands are added in 2234. Works fine! Thanks a lot.

[vvhillo]

Fireplace up and down don't work anymore since a few updates. If you click up or down a message box is displayed: WRONG CODE. I did not change anything. What is wrong?

[abc1000]

In another post, i'm also don't get Domoticz sending to Mertik receiver. Maybe a bug?
I'v firmware 1007 (the latest..) in my RFXtrx433e