how to copy data from watermeter to waterflow [Solved]

[Gravityz]

Hello,

i am using a nodemcu unit buy a wemos-d1-mini will work as well
it is running ESPeasy software
as a sensor i am using a LJ12-A3 proximity sensor which picks up magnetic disturbance

proximity-aansluiting.JPG (122.83 KiB) Viewed 660 times

proximity-aansluiting.JPG (122.83 KiB) Viewed 660 times

this thread will help you
i did not use a voltage converter but i used an optocoupler

https://www.twoenter.nl/blog/smarthome/ ... -domoticz/

[Gravityz]

i am using a nodemcu unit but a wemos d1 mini will work as well

input NodeMCU and Wemos D1 mini both have 3.3 inputs
sensoren work correctly on 5V

attach sensor to 5V but inputs through a pullup resistor to 3.3V

proximity-aansluiting.JPG (122.83 KiB) Viewed 660 times

proximity-aansluiting.JPG (122.83 KiB) Viewed 660 times

[Number8]

Thank you so much for the detailed information.

[Gravityz]

your welcome.
to be more specific, i checked and i have the sensor hooked up to D5(not D13)

[Number8]

the same goes for waterflow.
it turns out the esp pulsecounter sends out a time between pulse in ms. i use this number to calculate the exact flow and send this value over to domoticz.

Just another question: does the time value sent by esp pulsecounter is specific to espeasy? I'm wondering whether I could use Tasmota instead.