Zigbee smart Button TS004F Zigbee Manufacturer _TZ3000_rco1yzb1 not working

[hemant5400z]

Hi Guys,

Lidl HG08164 TS004F Zigbee Manufacturer _TZ3000_rco1yzb1. It is paired using Zigbee 2Mqtt and The device shows up in Domoticz like all my other devices.

Difference is that this is a selector button, but it does not work as expected.

When I using the btton 1 click device goes on, double click device turns off. But when I try to control in from Domoiticz selecting on/off de device in Zigbee2Mqtt is not updated and the smart button state stays the same.

I did not do anything special wit the button, it just came in after auto discovery. ( I can see 5 stages, but there are no selector actions).

Is there something in addtion i need to do to get this working?

Runing Domoticz version 2022.1 with latest version of the plugin for Zigbee.

Thanx Hemant

[HansOtten]

Sounds familiar to my experience with the Lidl Smart Switch. Same Zigbee2MTT setup.

Behaviour is the same, not of any use in Domoticz as is.

See viewtopic.php?p=294880#p294880

It seems you need to write scripts for it. See https://www.domoticz.com/wiki/Dummy_for ... tor_Switch

[hemant5400z]

Hhmm,

so no functionalit, and need to write scripts for each action. I was hoping that this simple device would just turn On/Off something and was planning to use it as a toggle switch.

no wonder they were 50% off

hemant

[HansOtten]

It is Domoticz which lets us down with this switch.

It seems to wrok fine in Home Assistent and with the Lidl gateway software.

Hans

[hemant5400z]

Unfortunately in not use HA.

I have domoticz en homebridge. To expose to homekit.

All logic is in domoticz and was not planning to use HA.

Hope someone had a nice trick.

Hemant