Simple event not working

[Sway06]

Hi!

I created my first event and it is not working. I am using the Xiaomi gateway with motion sensors and 433 mhz switches via a RFXtrx433 transceiver.

Could you please have a look and let me know what I am doing wrong?

The idea is to have a light on for 5 minutes anytime there is motion in the room.

Capture.JPG (57.49 KiB) Viewed 1060 times

Thanks in advance for helping out!

[Dave21w]

Try changing the detected state from motion to On

[Sway06]

Try changing the detected state from motion to On

Hi Dave,

Thanks for your reply.

I just tried changing the state from Motion to On but it didn't work. Looks like Xiaomi sensors need to have "Motion" state to work in Domoticz.

[Dave21w]

Strange, I have the Aqara sensor with the built in Lux level sensor and that definitely uses "on" for it's detected state - this is my blockly.

lux-motion.jpg (19.75 KiB) Viewed 978 times

Regards
Dave

[besix]

Nothing weird here. Time format. It must be in 5 minutes, not 00:05 because it's been 5 minutes past midnight

[Dave21w]

Well spotted !

[solarboy]

Just to add to the discussion, I have had blockly events turn themselves no a state of neither on or off before. I am not sure why it happens but I have not noticed right away. Something to always check before troubleshooting a non-functioning event.