Fibaro motion sensor not working in Blockly

[Koektrommel]

Hi all,

I am trying to configure a flood light to switch on after motion is detected. Attached a simple Blockly to test the motion sensor by writing a message to the log.

The motion sensor 'switch' does change state when motion is detected. Alarm events are recorded in the log.

2021-06-06 21:55:50.538 Status: Z-Wave Controller: OpenZWave: Alarm received (Home Security: Motion Detected at Unknown Location), NodeID: 22 (0x16)

However, I can't get the Blockly script to respond to motion detected and write to the log. Any ideas?

Thanks!
Jos

[Ron]

Maybe you should add another statement, If motion sensor is off and lampke is off
Do write to log motion on

I think it should use it like this, for me it works with this sensor.

My Blocky for the toilet sensor:

Knipsel.JPG (94.33 KiB) Viewed 589 times

[Blanche45]

Make sure the Sensor is powered.
Press and hold the B-button.
Wait for 4-6 seconds for the visual LED indicator to glow yellow (2nd position of the MENU)
Release the B-button.
Click the B-button, once.
Successful reset will be confirmed with the visual indicator changing colour to red and fading.

peryourhealth official