Zigate with Osram Lightify / Smart+ Motion Sensor / no values

[pocock]

I'm running Domoticz with the Zigate plugin.

I was able to join the Osram Smart+ (formerly Lightify) Motion sensor but I observe the following problems:

- each attribute (e.g. battery voltage) appears twice in Domoticz
- the temperature is always 0 degrees
- the battery voltage is always 0 V
- the switch state never changes (looking at the log view, it is always closed)

Could this simply be a faulty motion sensor, should I try to get it replaced? Or is it not fully supported yet?

Is there anything more I can do to troubleshoot this sensor?

[pipiche]

Hard to say.

I don't have one personally, so cannot really confirm if it works out of the box , or if it requires some fine tuning.

Logs would help, if you are able to put the logs in regards to some specific actions/expectations.

It short this would requires further investigation

[pipiche]

https://zigate.fr/produits-osram-compatibles-zigate/

Looks like the Motion sensor is not fully cooperative with Zigate

I'll investigate

[pipiche]

Could you try on Beta version ?
And provide me the DeviceList-xx.txt (at least the related entry for the OSRMA Motion Sensor)