DarkSky "LaCrosse TX3"

[Furry]

I have a DarkSky "Temperature" device of subtype "LaCrosse TX3" which reads -17.8C.

Can someone please tell me: what/where is this?

TIA

[alanlsmith]

Somewhere cold?

But seriously, all the dummy temperature sensors (including Dark Sky) that I have are shown as LaCrosse.

Have you enabled Dark Sky in the hardware section and if so is the location (on the planet) correct?

[Furry]

Yes, it's enabled (and all the other DarkSky 'sensors', and the forecast, work correctly), and the location is correct.

[alanlsmith]

Oh...

Is that the only Dark Sky temperature sensor and has it been updated recently. Also has any adjustment been applied to it under edit?

[Furry]

Is that the only Dark Sky temperature sensor...

No, there's also the Temp / Humidity / Barometer sensor, with subtypes "THB1 - BTHR918, BTHGN129".

... and has it been updated recently.

Domoticz has been updated many times recently, but I believe this sensor has been there for a long time.

Also has any adjustment been applied to it under edit?

Applied to what? How/why would adjustment/edit be done?

[alanlsmith]

No, there's also the Temp / Humidity / Barometer sensor, with subtypes "THB1 - BTHR918, BTHGN129".

Does the temperature on that read the same as the device you mentioned in your original post.

Domoticz has been updated many times recently, but I believe this sensor has been there for a long time.

I meant when was the last update of the temperature device itself.

Applied to what? How/why would adjustment/edit be done?

On the device itself in the web ui, click edit and you can enter a plus or minus figure to correct any inaccuracies (normally to correct the output of an actual physical device) I don’t know why this would be changed in your case but it’s worth checking to eliminate it.