Hello there ,
I'm searching for the solution of following problem in domoticz :
I am using a z-uno device with multiple channels setup :
1 Binary-Switch ZUNO_SWITCH_BINARY
1 Multilevel-Sensor Distance
1 Multilevel Sensor Tankcapacity
1 Multilevel Sensor General Purpose with Percent Scale
When I connect the device to domoticz the openzwave panel shows the devices as seen below
but in domotics only 1 multilevel sensor is seen beside the binary switches :
Any suggestions how to fix this problem ?
Regards Wolfgang
Z-Uno multiple Sensors not seen in Domoticz
Moderator: leecollings
- Ben0it
- Posts: 17
- Joined: Sunday 31 January 2016 21:22
- Target OS: Linux
- Domoticz version: 3.6745
- Location: France
- Contact:
Re: Z-Uno multiple Sensors not seen in Domoticz
Hello, I have the same problem using a custom Z-Uno sensor with four channels :
Is there an XML file (or else) I could possibly update to make these missing channels available in Domoticz devices
Best Regards,
- Relative humidity in %
- Air temperature in °C
- Air PM10 concentration (in µg/m3)
- Air PM25 concentration (in µg/m3)
Is there an XML file (or else) I could possibly update to make these missing channels available in Domoticz devices
Best Regards,
-
Benoît.
Benoît.
Who is online
Users browsing this forum: Google [Bot] and 1 guest