Multiple 'fake' sub devices

[billytkid]

Hi all,

Some of my zwave devices have lots of additional switches, above and beyond what is really there.

Examples below:
- Fibaro Universal Sensor - 17 additional sensors
- Pan04 - 27 Switches
- Quibino Flush 2 relay - 40+ switches!

When initially paired they all had the correct amount, but this number seems to creep up over time.

Q1 - Does anyone else see this?
Q2 - If so is there any reason why? I could understand if it was signal to one device/manufacturer, but it seems to be over multiple
Q3 - Is there a way for me to tidy this up without having to repair?

Thanks

[billytkid]

Examples below

Fibaro Universal Sensor.JPG (60.77 KiB) Viewed 929 times

Philio Pan04.JPG (96.02 KiB) Viewed 929 times

Quibino Flush 2 Relay.JPG (113.24 KiB) Viewed 929 times

[Ricard1]

I have same problem with ghost endpoints getting added over time... This is a OZW issue that I also have reported over there. Unfortunately OZW is more or less stopped in development so when this (and many other improvements) will be included is written in the stars...

[billytkid]

Thanks Ricard1.

OZW is dead in development...thats a worry... When did it stop?
Does that mean Domoiticz for zwave is also dead in the water?

[Ricard1]

Well, I should not say it is dead, more like snail speed... Z-Wave "as is" works of course but there is a lot of issues, just check https://github.com/OpenZWave/open-zwave

Many new devices are included to OZW no problem with that, it is lack in core improvements that holds back a some wider and stable Z-Wave experience on all platforms relying on OZW. I dont know for sure but the whole development seems mastered by one person whom explained "not have the time", same situation since long time back. What or when situation will change is the question...