Chuango Door Sensor and Blockly event not working

[magic]

Hi all,

Been struggling getting the following to work without success.

I have Chuango DWC 102 magnetic door/window sensor.
I have a RFXTRX433e.

Domoticz is correctly configured as in it receives the "Open/On" states from the door sensor.
I have an off delay configured on the door sensor of 5 sec, because it only sends 1 state and that is "Open/On"

I want to create a blockly event that sends me an e-mail or turns on the light when the door sensor is triggered Open or On, but the lights or e-mail is not triggered.

I have tried various states such as Open, Close, On, Off, Alarm... non works.

When I create a different event such as, when light turns on, send e-mail to X, this does work.

Schermafbeelding 2017-07-31 om 19.19.49.png (35.19 KiB) Viewed 904 times

Schermafbeelding 2017-07-31 om 19.19.42.png (61.27 KiB) Viewed 904 times

Schermafbeelding 2017-07-31 om 19.19.29.png (36.54 KiB) Viewed 904 times

[magic]

Schermafbeelding 2017-07-31 om 19.23.17.png (13.37 KiB) Viewed 902 times

Schermafbeelding 2017-07-31 om 19.23.33.png (12.91 KiB) Viewed 902 times

[magic]

Finally found what I did wrong....

The only difference between my test events which did work was that I had set my test events on "All" in the drop down box whereas the event with my door sensor I had set " Security"

Schermafbeelding 2017-07-31 om 20.14.49.png (36.7 KiB) Viewed 899 times