Problem FGMS001-ZW5 no LUX or TEMP device

[brommetje]

Hi all

Just bought an Aeon Gen5 Zwave controller (v3.2) with a Motion sensor FGMS001-ZW5. Problem is that only device id 200, 232 and 235 is recognized.
Installed/compiled OpenZwave 1.4-2435, Domoticz version 3.6953.

So only motion is working, problem is Lux device created but not updated and NO Temp device created, any one a idea?

Martin

[tontze]

Reset it, and include again. Usually it helps.

[brommetje]

Tontze, it is working now, after deleting the sensor and adding the sensor again I had the same problem no lux and temp device. But after about 1,5 hour the lux and temp device was there and it is working now.
Strange that it takes so long.
Thanks

[Egregius]

Values are only sent when the defined treshold is passed.

[tontze]

Values are only sent when the defined treshold is passed.

True, but devices should still be there before first value send right ?

[Egregius]

No, devices are created with first value. Keep in mind that accept new hardware must be enabled.

[brommetje]

In my case Accept New hardware is enabled by default devices created about 1,5 hour later.