Strange Energy Measurement of Aeotec Smart Switch 6

[irimi]

I have an Aeotec Smart Switch 6, recently a refrigerator is plugged for power and energy measurement.
Power measurement looks plausible but energy looks very strange:

Energy_Power.png (57.98 KiB) Viewed 1099 times

Most time energy is 0 Wh but suddenly there is a peak of 1000kWh resp 1MWh , then zero again.
Any idea ?

[EdddieN]

I have the same issue using a Aeotec ZW075 Smart Switch Gen5 (Wall plug switch). Power looks fine but energy peak is definitely not real.

Any idea where this is coming from? or even better how to delete it?

Using Synology with Domoticz Version: 3.5877

[Varazir]

Strange I can't get any value from my ZW075 Smart Switch Gen5 switch.

Edit : My problem was fixed with the latest beta

[EdddieN]

How long did you have it running? It usually takes a bit of time to start sending power or energy data.

Are you able to control it?

[EdddieN]

This has happened again but with a different socket (TKB), is this an issue with the hardware getting a jump for no reason? I wish I could see the logs of this entry received by Domoticz but probably realised too late...

Is there a way to find out if this is a Domoticz or hardware issue?

Screen Shot 2017-02-07 at 19.15.52.png (131.27 KiB) Viewed 912 times

[EdddieN]

Screen Shot 2017-02-20 at 21.03.01.png (250.91 KiB) Viewed 893 times

Does any one know how to remove the peaks? This has happened again with a different socket