Force off to rfxcom device even if state is off in domoticz

[multinet]

Hello

I´ve some shutter controlled by DIO rfxcom device

If I control the device by the local switch domoticz does not catch
The command so that it doesn't update the off to on status

So I can have a shutter opened (should be on in domoticz) with a status at off in domoticz

In that case In blocky the set device = off doesn't send the off command because it believe it is already off

How can I do either to have the correct status in domoticz or
To force the off in blockly even if the state is already off ?

Thanks

[Egregius]

Don't use the local switch
Or use a zwave device that sends it's state.
Or update the switch to off on a time.

[multinet]

Zwave is the good solution for sure but I will migrate to it Amin 2017

I found a trick in blockly : set on and then set off seems to work (force off to device even if the state if already off in domoticz)