Event don't start on variable state change

sorampage · Post by **sorampage** » Monday 12 December 2016 12:19

Hi all,

I think find a small problem with Blockly and variables.
If an event start when a variable state change, the event doesn't start ... You MUST add "TIME>00:00" for event check state of your variable every minutes.

Is problem known?

Thx.

Egregius · Post by **Egregius** » Monday 12 December 2016 12:26

sorampage wrote: Is problem known?

Yes, search forum.

sorampage · Post by **sorampage** » Monday 12 December 2016 15:20

I actualy use an hidden dummy switch, but it can be more clean with variables...
@Egregius, if you have a solution, share it !

sorampage · Post by **sorampage** » Tuesday 13 December 2016 10:55

The domoticz Wiki say .. User variables can trigger events ... No user variable can't trigged an event..

https://www.domoticz.com/wiki/User_variables

Is that a problem that is known? Is there a resolution?

Egregius · Post by **Egregius** » Tuesday 13 December 2016 13:07

http://www.domoticz.com/forum/viewtopic ... op#p107174

I don't use uservariables as I believe that causes needless stress on Domoticz, I use MemCached for that.

chrisfraser05 · Post by **chrisfraser05** » Sunday 05 February 2017 23:49

This is odd.....

I have a blocky event that works, it's only based on the user variable state. I never had to do the time fix.

Event don't start on variable state change

Event don't start on variable state change

Re: Event don't start on variable state change

Re: Event don't start on variable state change

Re: Event don't start on variable state change

Re: Event don't start on variable state change

Re: Event don't start on variable state change

Who is online