Domitech ZE27EU don't report status, and set random dim-levels

[Evelen]

Hei.
yesterday i included a Domitech ZE27EU Z-wave dimable bulb, it works, kind of, but not good.

If I change the state to off with domoticz it for no reason change the dim level after i turned the device off

Code: Select all

2016-10-26 21:20:45	Set Level: 95 %
2016-10-26 21:20:45	Off

after this the light is in fact off, but in domoticz it is on.

if i wait a little I can turn it off in domoticz again and it will be off.

Code: Select all

2016-10-26 21:32:58	Off

then I turn it on:

Code: Select all

2016-10-26 21:33:45	Set Level: 6 %
2016-10-26 21:33:45	On

why 6%? i did not change that.

in domoticz it is now on at 6%, but it is realy more, (100%?)


I don't have this issue with other lights, this is the only I have of this model.
Tryed to update to last update (Version: 3.5818) and restartet domoticz, no help in that.

this is my settings for Domitech Smart LED Retrofit Kit ZE27EU:

Uten navn.png (369.94 KiB) Viewed 2360 times

I use UZB1 OpenZWave,
1.4-2215-g139c076-dirty

[Evelen]

bump

[Evelen]

bump

[ceedebee]

Did you enabled polling? That worked for mine bulbs.

[Evelen]

Did you enabled polling? That worked for mine bulbs.

did not work for me

[Evelen]

I did reset the node, then it was dead in domoticz, removed it from OpenZWave control panel.
then included it again

"2016-10-31 22:20:51.500 User: flemmingss initiated a switch command (202/30 - Level/Set Level)
2016-10-31 22:20:51.500 OpenZWave: Domoticz has send a Switch command!, Level: 99, NodeID: 27 (0x1b)"

still works the same way

[Martinq]

Mine has the same problem. Polling helps to let Domoticz know it's switched off, but it still will take some time to update the status.

[mistermister]

I have the same trouble with the Domitech ZB22UK bulb - The status does not update in Domoticz when it's turned on/off, and it randomly sets levels when turning on/off. Anyone had any luck fixing either bulb? Turning on polling does help, but obviously this has a latency that will get worse the more bulbs I add to the system. The Set % does not seem correct, either.

Does anyone know if this is a problem with the bulb itself, or if it's Domoticz/Open Z-wave? Wanting to know whether I should return the bulb and try a different brand.

[anasazi]

I also bought this lamp and experience the same issues as you.
Has anyone been able to solve this?
Enable polling might be a solution I think it should work without this enabled...

[odelay]

Any news on this one, did anyone got it to work with Domoticz already?
This reseller tells it is compatible https://www.robbshop.nl/domitech-e27-z- ... s-led-lamp

[Padster]

I have the exact same problem. Any news?

[RoyT]

Nope, still the same issue here.