I have used S_DUST/V_LEVEL to display percentage. Have a look at https://forum.mysensors.org/topic/5157/ ... ant-volume

Hi! I think I must have had the beta builds ticked at some point as now it's not updating versions. Is there a way to get it doing package updates again without uninstalling and re-installing? Thanks! Add http://www.jadahl.com/domoticz_beta/ to your Synology NAS Package Center sources. Just to ...

provided you have domoticz set to "accept new hardware devices" in settings then if the rflink sees and can understand the the nodo small it should then just show up in the device list. Do any other 433mhz devices show up via the rflink?

I have a MySensors serial gateway working on my Synology.

leonp Are you asking if you can use the i/o pins of the arduino that is being used for the RFlink ? If so I would not think that would be a good idea (even if it is possible), the RFlink firmware is being updated all the time and you would have to keep adding your modified code every time. You would ...

That seems to be all ok. mine shows this after i power cycled mine (mine is on synology nas) 2016-01-26 20:32:53.634 Error: Serial Port closed!... Error: End of file 2016-01-26 20:32:53.724 RFLink: serial retrying in 30 seconds... 2016-01-26 20:33:24.272 Error: RFLink: Error opening serial port ...

It is certainly possible. You will need to add a 433mhz gateway device to your Domoticz setup , such as the rfxcom unit http://www.rfxcom.com/en_GB or if you can diy the rflink unit http://www.nemcon.nl/blog2/ Once you have a gateway you can either build the relay controller using something like the ...

Hi
I am also just starting out with Domoticz and Mysensors so probably not much help in diagnosing your problem. I can tell you the relay sketch is working for me. I am just switching a LED not a relay but that should make no difference I would think.

I am using 2.0.4210-7

Have a look here for some ideas

http://www.domoticz.com/forum/viewtopic.php?f=28&t=7866

https://www.domoticz.com/wiki/Logitech_Media_Server

Thanks will have a look I have managed to increment the volume using a mysensors rotary encoder to activate a dummy switch in domoticz. the dummy then sends the json request http://192.168.2.55:8084/json.htm?type=command&param=lmsmediacommand&idx=73&action=VolumeUp this then up's the lms volume by 2 ...

That is a pity, it would have been a much more seamless way to change the volume. I am trying to have the switch plate aware of changes made to the player by other devices eg. a tablet or smart phone. If I just use the lua set volume without knowing what the current volume is it will be a bit messy ...

Can anyone tell me if it is possible to retrieve the current volume level of the player? I am trying to make a mysensors hardware device to control the player but need to get the current volume so I can increment it up or down.

thanks