Parameter 3 specifies the timeout in seconds before sensor will send status off, according to description, so it will send 'off' status to controller. Parameter 2000 specifies a wake-up time in seconds . Both need a value. See example in config settings screenshots in this topic. That should make it ...

@Het-Licht. As posted by other member: If enhancing the manufacturer details works you should submit a patch request to OpenZWave so they can add it to the default config. Its a great way to give back to the open source community and everyone benefits from your investigation. Something like this ...

@MultiZW074 I agree that it should not be a requirement for configuring the device that polling is enabled. USB power should prevent it from going into sleep mode. It was just an extra measure in case the sensor would for some reason, to awake it in that case. Motion indeed is triggering a message ...

@het-licht Parameter 3 defines the timeout for motion, in my case 240 seconds. Make sure you stay out of range in between motions because it will directly sense motion. I guess that is a non brainer :-) When configuring a new multi sensor, put it on USB power and make sure polling is enabled. That ...

@Dnpwwo. I have submitted the issue with OpenZWave. Thnx for the suggestion.

In addition to previous post (I could only add 3 pictures): Devices overview after configuratation: devices.JPG Switches overview: (The alarm sensor device type has been changed to type 'motion sensor' (default is on/off): No motion detected: switches status off.JPG With motion detected switches ...

As requested configuration of Aeon Gen5 multisensor (inside of sensor has sticker 'Multisensor Gen5, model ZW074-C) Keep in mind configuration settings are made available by changing the manufacturer_xxx.xml file described in my previous post. Node settings: node management.JPG Configuration: Config ...

@het-licht You still have a double entry for the aeon multi sensor in the node setup and I also see the devices twice. I assume you only have 1 device though. Select the node button and exclude the device, or select the node and select the option to ' remove' node. Also check then that all devices ...

Hi, Did you exclude the sensor from 'Node managment' and did you check all devices were removed? You might want to restart the server/raspberry afterwards. After doing so, and making the changes to the manufacturer_xxxx.xml file described before, the sensor should be recognized. The only thing I ...

Hi, in the /domotics/Config directory there is a manufacturer_specific.xml. Find the entry: <Manufacturer id="0086" name="Aeon Labs"> <Product type="0000" id="0000" name="Z-Wave Extender"/> <Product type="0001" id="0001" name="Z-Stick"/> <Product type="0001" id="0002" name="Z-Stick S2"/> <Product ...