I have swapped my ATC928G2000 (V2) in a fully working setup for a ATC928G3000 (Wifi) and I'm am running into some issues regarding parts of the HGI80 connectivity. My main problem is that custom sensors are bound, but do not update. I've tested two scenario's: 1. Just leaving all devices in domoticz ...

I have the same problem (EvoTouch V3). Setting it to Off does not do anything and the first web update retrieves the state 'Unknown' and much later I think it continues to Auto. After a quick check, I see that it is a problem with the consistency of the index numbers in the Domoticz frontend/DB ...

@DanD Thanks! That seems like a plausible explanation indeed. I'm controlling the same boiler, but one thermostat is using an Opentherm protocol (the living room), and the relay switch will operate in parallel in case of extra heat demand for other rooms. This is possible (tested) on my Remeha ...

I wanted to add a success story as well. My HGI80 just arrived and worked straight out of the box, in contrast to my fullTalgoRythm attempt that did receive, but was unable to send properly. All six HR80/HR92 radiator controllers are properly read out and setpoints are transmitted. Because I don't ...

Thanks DanD, that's great! I'll try to get the fullTalgoRythm FW to send properly and scout for a secondhand HGI80 in the meanwhile

Interesting... Would it be possible to directly send/receive setpoints to/from a HR80 or HR92 using the HGI80 this way? Without the Evotouch controller in between?
I'm experimenting with the fullTalgoRythm/EvohomeWirelessFW firmware, but still unsuccessful at this point.

A kind request to the Evohome users on the forum: I'm setting up a Domoticz-based Evohome system, but am looking for 5 sets of adapter rings for the Danfoss RAVL radiators that come standard with new HR80. I hope one of the forum users are willing to offer me their not used adapter set so I can ...