Same issue here after 2024.2 update.

Is there any progress or update to this item?
Recently I did buy an RFLink gateway with 868 MHz module. Like to connect to my Orcon MVS-15RHB house ventilation system with 15RF wireless controllers through the gateway.
RFLink will be connected to current Domoticz system running on Raspberry hardware.

Same issue on my end. Electra OK (all 4) but Gas reading 0.00. Problem did start with the switch to 2016. Hardware platform: Raspberry 2B. Domoticz version: V2.3530 Additional info: Just checked my "SlimmemeterPortal" data. For Jan 1, I do see Electra usage but no Gas usage (only temp graph, Gas = 0 ...

Sorry did forget to answer your question on direct connect. At this moment connection still is through wired LAN. Hope in the near future we will get options in Domoticz to connect through RS485 or USB.

@asg, not seen that till now at all. Do parallel power/energy measurement of my SolarEdge system through DIN rail KWh meter with Youless. Timing between the 2 measurement systems is completely different (5 min versus 10 sec interval). During power generation this does give differences in read-out as ...

In the meantime my SolarEdge – Domoticz setup is running on my test system now stable and reliable for more than 2 weeks. Also the SolarEdge site is updated as expected. Additional, the Master-Slave setup between the 2 Domoticz systems is working stable for the SolarEdge information. SolarEdge u ...

OK, functioning now on my test system. No error messages on SE5000 or in Domoticz. SolarEdge site logging info as normal so Domoticz forward also is working fine. Will monitor this for the coming days so we collect some info. In regards to a Wiki or Domoticz manual modification for the SE add-on ...

Thanks for your quick reply. Used the SolarEdge config tool multiple times, so pretty well known with it in the meantime. Also found the SolarEdge IP and port info in my router logging, so that's available anyhow. Standard SolarEdge logging currently is stable and working as expected. As a test I ...

If possible I like to blow new air in this conversation. Is there in the meantime any progress made on implementing SolarEdge directly and fully (optimizers included) in Domoticz? Would be very nice. Tried to get it working through LAN but no result yet. Also the Domoticz manual still is pretty ...