I did manage to figure this out. It had nothing to do with Nodes.

I figured out that by clicking the SETUP icon on the Z-stick then showed me connected devices. From there I could add them individually.

The light switch and the bulb are synced to the z-stick according to the z-stick instructions. The z-stick hardware is showing up in Domoticz. I am not following on the Node part. What does the Node have to do with getting the devices to show up in the Switches menu. I am pretty sure I did not do ...

that is my question. How do I "re-add" them?

I should note that my z-stick shows up in the Hardware screen with the following...

Idx: 2
Name: Z-stick
Enabled: Yes
Type: OpenZWave USB Version: 1.4-2713-ge2021e46-dirty Setup
Port: /dev/ttyACM0
Data Timeout: Disabled

I have a new install of Domotiz up and running after a Raspberry Pi crash. I can't seem to get my z-wave devices back into Domoticz. I seem to have a z-wave lightswitch and a smart bulb synced up with the z-stick. To do this I pulled the z-stick from the RPi. Went to the devices. Pressed the z-stick ...

I am running Domoticz on a Rasapberry PI. I just purchased at Z-wave light bulb and not sure how to set it up. I using a Z-stick gen 5 for my controller and I have synced the bulb to the Z-stick just fine. It flashed as expected for a sync. Back in Domoticz I have a manual setup option and a Learn ...

I am not sure if it possible to get my current setup working in Domoticz but I am half way there and looking for some assistance. I have looked to the camera wiki page and it has allowed some success. My current setup has several USB camera attached to their own RPI and an RPi running MotionEye as ...