Hi sander815 did you ever get any response on your question? If you have three meters that you want to monitor via Domoticz, it might be an option with this S0 device: S0 Pulse Counter Module (5 Poorten) http://www.smartmeterdashboard.nl/webshop I'm sure that the ESP8266-01 can't be used as the ...

I'm having the same problem, showing the first graph is fine - all through the graphs is a bit pointy - but showing the next sensor produce no graph
I have the paid version

Keep up the good work

BR
Lars

Hi all I just wanted to make an update on my project It's now running with the two panStamp boards based on the ESP8266 to controll all floor heating in my house. I had so solder wires directly on the chip in order to get GPIO0, GPIO2 and GPIO10. I did try GPIO9, but that is not working correctly ...

Hi all I have now made a small test where I'm using a relay board with ESP8266MOD. The board has been flashed with ESPEasy R147. I'm able to control the relay using a http call! As I want to make this a autonomous solution, I did attach one DS18b20 thermometer to GPIO16 pin (direct soldering that is ...

Hi Baptist many thanks for your reply :-) Any chance that you could describe your solution a bit more detailed? What are you using on the ESP8266 as firmware? Is it correct that the ESP8266 reports the temperature to Domoticz, but takes action by themselve if temperature are under over the setpoints ...

Hi all not that I have been swamped by ways to convert my Domoticz server into a Heating Controller, but I now have an idea that might do the trick Getting a ESP8266 with 6 or 12 relay output and a spare GPIO for temperature input via either DS18B20 or DHT22. <-- That could be broken into two ...

Hi saiko I'm just using plain ESP8266-01 where I flash ESPEasy on. That is for my sensors. I still haven't figure out a relay board I can use! Note that I need to operate 13 individual Valves, therefor I need a board with at least 13 relays BR Lars Hi Lars, Which ESP8266 are you using? I'm using a ...

Hi there I'm thinking of turning my Domoticz server into an controller for my central heating. Temperature could be collected via ESP8266/ESPEasy and a number of DS18B20 probes! There is already wiring to all rooms to run the old Thermometers. It's all floor heating, so all my "Telestater" Valves ...

Hi Danoussh the question was of a more general kind, not just 1-Wire. As I'm new to this, I would like to use others experience in this field. Why am I listing 1-Wire first? I don't know, just the first I read about. I found a 1-Wire relay here: http://denkovi.com/1-wire-eight-channel-relay-board ...

Hi all I need help in choosing the correct hardware to various jobs. Right now I like to get some temperature measurement and that points to 1-Wire! Right? At the same time I would like to use the Domoticz system to control my awning. Just a manual control to operate it out or in. Later on that ...

Hi all I'm new to Domoticz, but I'm getting there I have been following this thread the last two month, and I have a Denon AVR-3312 that I would like to integrate into my Domoticz server. My first question is, how to add the Virtual switches that is shown in this thread? I like to see something like ...