Domoticz

Dear Members,

I purchased some cheap Temp/Humid sensors from Amazon.de. (€9,99)

http://www.amazon.de/Transmitter-Froggi ... ds=froggit

I like these over many other sensors because of the small size, LCD screen, 8channel and IP rating.
I kind of hoped (expected?) these would work with the RFXcom TRX433E.
however, they are not detected by Domoticz.

In RFXmngr (in undec mode), I receive the following:

Packettype = UNDECODED RF Message
UNDECODED ARC:0F8440

(unit set in CH1)

How to get this device working in Domoticz?
I am not a programming type of guy ,so I'm also willing to donate a unit to the dev. team so they can add support for this device.

The rear of the device: Anyone knows this?

Thanks!

Please contact support at rfxcom.com

Big chance that b_weijenberg will get it working, i have good experiences with him when i sent him a device (cheap Banggood sensor).

Please report back here if it works, i am also interested.
I have subscribed to this topic (button at bottom of the page) so i will get a mail notification when a reply is posted

OK, thanks guys..I will contact Support and inform about the results on this forum.

Anything new to report on this?

The F007TH is not (yet) supported by the RFXtrx.
This one is supported: http://www.banggood.com/433MHz-Wireless ... 65559.html

Thank you.

b_weijenberg wrote:The F007TH is not (yet) supported by the RFXtrx.
This one is supported: http://www.banggood.com/433MHz-Wireless ... 65559.html

I bought this one. However I cannot find it in Domoticz. Anyone using this sensor care to explain how?

thank you
Daniel

The RFXtrxE works perfect with F007TH in Domoticz v3.8153.
You must ensure the RFXtrxE use firmware Ext2. I run RFXtrx433_Ext2_1022.

See below.