Domoticz

Posted: **Tuesday 14 April 2015 20:40**

Hope you can help me with this strange one. I've the following event defined:

: Screen Shot 2015-04-14 at 20.34.20.png (54.8 KiB) Viewed 979 times

And for completeness I've the following to switches which are coupled to a PiFace on my Raspberry

: Screen Shot 2015-04-14 at 20.34.34.png (47.64 KiB) Viewed 979 times

When the DoorBellRinger is pressed the event (shown above) is started as I'm receiving notifications on my iPhone and also an email. But my bell doesn't ring! Strange. When clicking on the switch itself I can enable and disable the bell itself without any problems. This means the PiFace configuration is working.

The log file shows the following (two door bell presses):

2015-04-14 20:39:17.676 (PiFace-1) RFXMeter (Unknown)
2015-04-14 20:39:17.688 (PiFace-1) RFXMeter (Unknown)
2015-04-14 20:39:26.130 Notification sent (Pushover)
2015-04-14 20:39:26.134 Front Doorbell Pressed.
2015-04-14 20:39:26.135 Event: triggered: DoorbellPush_1
2015-04-14 20:39:25.542 (PiFace-1) Lighting 1 (DoorBellRinger)
2015-04-14 20:39:27.073 Error: Piface: wrong housecode I
2015-04-14 20:39:27.073 (PiFace-1) Lighting 1 (DoorBellRinger)
2015-04-14 20:39:28.067 Notification sent (Email)
2015-04-14 20:39:28.085 (PiFace-1) Lighting 1 (DoorBellRinger)
2015-04-14 20:39:28.515 (PiFace-1) RFXMeter (Unknown)
2015-04-14 20:39:28.528 (PiFace-1) RFXMeter (Unknown)

Any suggestions on this strange behaviour?

Posted: **Monday 18 January 2016 16:42**

I have the exact same issue. I noticed that if I pushed the button longer it would ring but not with a short press.
Although the short press is being recognized as an event. But it didn't trigger blockly.

Perhaps it doesn't have enough time to trigger my relay switch?

Domoticz

Event started but bell not ringing

Event started but bell not ringing

Re: Event started but bell not ringing