Sending Wind Measurements from Tasmota
Posted: Tuesday 16 June 2026 22:01
I bought wind speed and direction sensors. Both operate on RS485. I'm not a programmer, but using AI, I managed to receive the measurements from the sensors in the Tasmota console. However, I've been struggling with the AI for three days to send the results to Domoticz, and I still can't get it to work. Below are the console logs, which show the wind speed and direction values (in degrees) that interest me. Can anyone tell me how to send this data to the Domoticz Wind Sensor?
Code: Select all
20:41:40.174 CMD: ModbusSend {"deviceaddress":4,"functioncode":3,"startaddress":0,"type":"uint16","count":1}
20:41:40.188 RSL: RESULT = {"ModbusSend":"Done"}
20:41:40.228 RSL: RESULT = {"ModbusReceived":{"DeviceAddress":4,"FunctionCode":3,"StartAddress":0,"Length":7,"Count":1,"Values":[484]}}
20:41:55.654 CMD: ModbusSend {"deviceaddress":3,"functioncode":3,"startaddress":0,"type":"uint16","count":1}
20:41:55.669 RSL: RESULT = {"ModbusSend":"Done"}
20:41:55.708 RSL: RESULT = {"ModbusReceived":{"DeviceAddress":3,"FunctionCode":3,"StartAddress":0,"Length":7,"Count":1,"Values":[0]}}