Domoticz

Posted: **Sunday 07 September 2025 20:23**

Motion status is not functioning anymore on my SonOff SNZB-03 detector via Zigbee2MQTT. This is what domoticz log says:

Error: MQTT homeassistant: sending switch commands for switch type 'binary_sensor' is not supported (yet...) (0x00124b002e77fc64_battery_low_zigbee2mqtt/pirBadkamer)

Posted: **Sunday 07 September 2025 20:29**

Did you try the latest Domoticz beta?

Posted: **Friday 12 September 2025 8:58**

You can not switch commands to a motion sensor.

This sensor should turn itself off after some seconds/minutes, probably you can configure this
If it does not, edit the motion sensor in Domoticz and specify a off delay (for example 60 seconds), they it will turn off after 60 seconds

Domoticz

'binary_sensor' is not supported (yet...)

'binary_sensor' is not supported (yet...)

Re: 'binary_sensor' is not supported (yet...)

Re: 'binary_sensor' is not supported (yet...)